PRIMERGY TX150 S7 Installation Guide Page 54

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 53
50 Options Guide TX150 S7
Expansion cards and BBU
Figure 35: Example: Connecting the BBU cable to the controller
Ê Install a controller as described in the section "Installing an expansion card"
on page 44.
Ê Route the BBU cable in the cable clamps and connect it to the controller.
V CAUTION!
Make sure that the connector side with the blank pins is facing the board.
Otherwise you risk short-circuits.
Ê In the case of a configuration with two BBUs:
Ê Install a further controller.
Ê Route the BBU cable in the cable clamps and connect it to the controller.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 79.
7.2.2 Installing BBU (BBU fixation 2)
You can install up to two Battery Backup Units (BBU).
I There are different BBUs available.
Ê Open the server as described in the chapter "Preparation" on page 19.
Page view 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 99 100

Comments to this Manuals

No comments