TX150 S7 Options Guide 69
10 Conversion from a floorstand
model to a rack model
V CAUTION!
Follow the safety instructions in the chapter "Safety instructions" on
page 11.
Figure 60: Removing the anti-tilt bracket
If the floorstand model is equipped with an anti-tilt bracket:
Ê Remove the two screws (1).
Ê Lift the server slightly and remove the anti-tilt bracket.
Ê Open the server and remove the front cover as described in the chapter
"Preparation" on page 19.
I The front cover is no longer required.
I The right-hand side cover and the top cover build one part.
0
0
Comments to this Manuals