PRIMERGY TX150 S7 Installation Guide download pdf (Page 31)

TX150 S7 Options Guide 27

5 Main memory

V CAUTION!

● Before installing/removing memory to/from the server, turn off the

server, all peripheral devices, and any other connected devices. Also

unplug all power cables from the outlet. Failure to do so can cause

electric shock.

● A memory module consists of parts that are very vulnerable to

damage by static electricity, and can easily be damaged by static

electricity in the human body. Before handling memory modules, first

touch a metal part of the server to discharge static electricity.

● Do not touch the circuitry on boards and soldered parts. Hold the

metallic areas or the edge of the circuit boards.

● Do not install unauthorized third party memory modules. Doing so

may cause electric shock, a fire, or failures.

● Wait for a sufficient period of time after server shutdown before

installing or removing memory modules. Failure to do so may cause

burns. When installing or removing memory modules, make sure to

remove the screws at the specified points only. Failure to do so may

cause injury. It may also cause failures.

● Touch only the specified part of the printed circuit board. Failure to do

so may cause injury. It may also cause failures.

● Do not insert and remove memory modules repeatedly. Doing so may

cause failures.

● If the memory module has not been correctly inserted, it may cause

a fire. Insert the memory module with attention to its direction.

● If a memory module is installed and you pull the securing clips

strongly outward, the memory module pops up. Doing so may cause

a device failure.

● Follow the safety instructions in the chapter "Safety instructions" on

page 11.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

No comments

PRIMERGY TX150 S7 Installation Guide Page 31